PCAN-USB PCAN2+ Cummins Diagnostic Adapter Cummins ECM calibration Tool Support Cummins INSITE V8.9 and V9.0
Introduction:
The Cummins Inline 6 tester can only use versions before 8.7, which are stable and effective. After the official upgrade to Cummins Insite Software V8.9 and V9.0, the Cummins inline 6 tester is no longer suitable. The new version Cummins Insite Software V8.9 and V9.0requires the original Cummins inline 7 tester. If you do not have the original Cummins inline 7 tester, you can purchase our PCAN-USB PCAN2+ Cummins Diagnostic Adapter in place, which can also support ECM calibration of Cummins Insite Software V8.9 and V9.0.
Features:
– A professional automotive bus development tool that supports for pcanexplorer.
– Supports for pcantrace, which enables CAN messages to be quickly recorded, saved, and even replayed on the CAN bus.
– Support ETAS and same star bus development and simulation software.
– Suitable for Linux and for MacOS operating systems.
– Applied to forklifts, construction machinery, and industrial automation.
– Support for CodeSys software for program debugging and downloading of PLC.
– Support for CANmoon software for programming and downloading EPEC and other controllers.
– With optocoupler isolation
– Compatible with German CAN card-USB IPEH-002021 IPEH-002022
– Support for BAIC, Chery and other new energy software
– Support INCA 7.0 7.1 7.2, etc.; can replace es581
– Support ecu computer board calibration, data reading, flashing
– Support epec software
– For Woodward
– Support software for ZAPI
– With 2500V isolation, safe to use
– Support for pcanview, pcanexplorer and other software. As long as software is supported by the the original product, it can also be used by our product
Specification:
– Firmware version: 8.4
– Firmware upgrade: not support
– Supported driver version: 4.2.1 or later
– Chip solution: for Freescale/ST
– USB cable length: 0.8m
Package Included:
– 1 x USB to CAN Adapter
– 1 x DB9 Wiring Terminal Adapter
– 1 x Screw Driver
There are no reviews yet.